To install it, get connected to a wired connection, open a terminal and type these commands: On 64 bit system, native support with brcmfmac for this chipset did not work. Now, if you haven’t done it already, right-click the network icon in the menu panel, and select “Edit Connections”. You should see the wireless icon a pile of arcs in the top bar, and a left click on it should show the nearby access points. Click the Wireless tab, and add a connection or edit the existing one.

Uploader: Brall
Date Added: 15 August 2010
File Size: 17.49 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 63933
Price: Free* [*Free Regsitration Required]

Turns out it was easy. The firmware used to linksys wpc54g linux in linux-firmware-nonfree, but it had been removed the last time I looked. Page History Login to edit. Can be setup easily under Intrepid 8. Get recognized in the setup process, but unable to use it. Image icons used on this site are courtesy of Oxygen-icons.

The Official Ubuntu Book 6th Edition. Chipset Driver Supports network install?

Ran apt-get update and card was found. This card is version 1. After installing the card, I had to enable “Broadcom STA wireless driver” in the hardware drivers manager. My card is a WPC54G v3. Then linksys wpc54g linux reboot and run “gksudo network-admin” in console and configure eth0.

Is not linksys wpc54g linux by Jaunty. The pre-configured driver package in that post has done this already. Yes In Ubuntu Hardware recognized immediately upon startup. WPA works with ndiswrapper according to this howto: Luckily, there’s a B43 firmware update available.

We’ve tested some cool tools for IT Admins. This is the fourth time Linksys wpc54g linux reinstalled Lubuntu. Version Chipset Driver Supports wpc5g4 install?

Please Review Our Privacy Policy. I’m new to linux.

Click the Wireless tab, and add a connection or edit the existing one. Enter the SSID of your linksys wpc54g linux network and enter your security key, and you should be good to go!

Linux Drivers for wpc54g

I’ve read several posts and tried several suggestions but nothing seems to linksys wpc54g linux the specific hardware I’m using. In Feisty installing Broadcom firmware here will get v. Your linsys has a Broadcom chip, which the b43 driver runs just fine.

Needed to modify the Ralink driver or simply use the linksys wpc54g linux version available at this post: Works “out of the box” in Karmic.

HOwever, the firmware for the chip must be installed by you.

Linksys WPC54G wireless card and Ubuntu

This site uses cookies to deliver our linksys wpc54g linux and to show you relevant ads and job listings. Copied and pasted “sudo apt-get install bfwcutter” into LXTerminal as you advised.

Using the wired connection: